fa گروه سرامیک Ceramic Materials and Engineering Research Paper Research Paper The effect of addition of NaHF2 on the cement setting and the set mass has been studied as an initial step to determine how fluoride influences the characteristics of a calcium phosphate cement, consisting of tetracalcium phosphate [TTCP:Ca4 (PO4)2O] and dicalcium phosphate dihydrate [DCPD:CaHPO4.2H2O].NaHF2 [0-10% wt% of powder phase] has been dissolved in double distilled water and used as the liquid phase of the apatite cement (AC). Powder X-ray diffraction analysis and FTIR measurements revealed that fluoride was necessary in promoting the formation of the apatite phase. The setting time was decreased significantly by the addition of NaHF2from 0% to 6%, but increased resulted in the AC (8-10%). The set AC (2%) has the highest compressive strength and the lowest porosity.The dissolution rate of set AC in weak acid, pH 5.5, was decreased with the amount of added NaHF2 from 0% to 6% but increased in the set AC 8-10%.The formation of fluoroapatite in AC (6%) was provided the low solubility and good acid resistance which is necessary for dental application.SEM observation showed needle-like apatite crystal growth over particulate matrix surface, however the amount of non-reactive TTCP or DCPD particles decreased by the addition of NaHF2. The Ca/P ratio, which was determined by EDAX, increased significantly with the addition of NaHF2. Calcium phosphate cement, Hydroxyapatite cement, Fluoroapatite cement, Dicalcium phosphate dehydrate (DCPD), Tetracalcium phosphate (TTCP), Sodium hydrogen fluoride (NaHF2) 9 15 http://ijmse.iust.ac.ir/browse.php?a_code=A-10-1-37&slc_lang=fa&sid=1 NOJEHDEHYAN H. 1800319475328460093 1800319475328460093 Yes MOZTAR ZADEH F. 1800319475328460094 1800319475328460094 No MIR ZADEH HAMID 1800319475328460095 1800319475328460095 No HESARAKI S. 1800319475328460096 1800319475328460096 No KEYANPOUR-RAD M. 1800319475328460097 1800319475328460097 No