A. Ait Yala, N. Demouche, S. Beddek, K. Hamid,
Volume 15, Issue 4 (December 2018)
Abstract
Repairing a crack in a structure consists in reducing crack’s tips stresses by transferring loads trough a bridge made of the composite patch and the adhesive. This operation is impacted by four factors: shear modulus of the adhesive, the composite patch’s Young module and the thicknesses of these two materials. The design of experiments method allowed us to determine, the weight of each of the four factors and their interactions as well their best combination to obtain an efficient and lasting repair. The constraints relative to the stiffness ratio and the shear strain were taken into consideration in order to determine the best configuration that allowed the minimization of K.
M. Demouche, E. H. Ouakdi, R. Louahdi,
Volume 16, Issue 3 (September 2019)
Abstract
In this study, high-carbon, chromium alloy steel (100Cr6) having the initial spheroidized microstructure was welded using the rotary friction welding method. The effects of process parameters such as friction time and friction force were experimentally investigated. The friction welded joints were produced of two 100Cr6 steel rods. In order to examine the microstructure and mechanical properties of the friction welded 100cr6 steel joints, tensile and hardness tests were conducted. The microstructure of weld zone was examined by optical microscopy. It was found that after cooling, martensitic structure is obtained at the core and periphery of the weld joint. It was found that the tensile strength of friction welded samples is increased with increasing time and force of friction up to a certain level and then decreases again. Hardness measurements show a higher hardness at the centre of the weld joint in comparison with its periphery.
